PCB Spiral Inductor Designer
Planar spiral coil: inductance, DC resistance, rough Q, self-resonance, and current from turns, width, spacing, and outer diameter.
Key points
PCB Spiral Inductor Designer: Planar spiral coil: inductance, DC resistance, rough Q, self-resonance, and current from turns, width, spacing, and outer diameter. Formula: L = K1·µ0·n²·d_avg/(1+K2·ρ)|d_in = d_out − 2n·w − (2n−1)·s. Enter parameters on the DD-CAT IDE online tool page to get results instantly, with a calculation-model diagram that updates with the inputs. Modified Wheeler current-sheet model (Mohan et al. 1999), ~10% accuracy, suitable for initial sizing; precise inductors need EM simulation. To raise Q: widen the trace, increase spacing, keep ρ at 0.5–0.7, use 2oz copper, or switch to octagonal.
Inputs
L = K1·µ0·n²·d_avg/(1+K2·ρ)|d_in = d_out − 2n·w − (2n−1)·sCalculation model (updates with parameters)
| Inductance L | 650.3 nH | modified Wheeler · square(Mohan 1999) |
| Inner diameter d_in / fill ratio ρ | 2.20 mm · 0.64 | Q is optimal around ρ ≈ 0.5–0.7 |
| total coil length / DC resistance | 0.24 m · 604.4 mΩ | |
| Q @ 1 MHz | 6.8 | DC model (skin / proximity not counted) |
| Self-resonant frequency SRF (rough) | 83.27 MHz | inter-turn parasitic ≈ 5.617 pF(lower-bound estimate) |
| Current capacity (ΔT=20°C) | 1.006 A | IPC-2221 outer-layer model |
Engineering notes
- Modified Wheeler current-sheet model (Mohan et al. 1999), ~10% accuracy, suitable for initial sizing; precise inductors need EM simulation.
- To raise Q: widen the trace, increase spacing, keep ρ at 0.5–0.7, use 2oz copper, or switch to octagonal.
- Operating frequency should stay below 1/3 of SRF; for high current, check capacity and consider paralleling layers.
FAQ
- What is PCB Spiral Inductor Designer for?
- Planar spiral coil: inductance, DC resistance, rough Q, self-resonance, and current from turns, width, spacing, and outer diameter.
- What is the formula for PCB Spiral Inductor Designer?
- Core formula: L = K1·µ0·n²·d_avg/(1+K2·ρ)|d_in = d_out − 2n·w − (2n−1)·s. The tool returns results instantly using this formula and the selected parameters.
- What engineering notes should I keep in mind when using PCB Spiral Inductor Designer?
- Modified Wheeler current-sheet model (Mohan et al. 1999), ~10% accuracy, suitable for initial sizing; precise inductors need EM simulation. To raise Q: widen the trace, increase spacing, keep ρ at 0.5–0.7, use 2oz copper, or switch to octagonal. Operating frequency should stay below 1/3 of SRF; for high current, check capacity and consider paralleling layers.
Embed this calculator on your site / blog / intranet
Copy the snippet below into any HTML-capable page — visitors get the same live calculator, styling included.